| |
   
Morovia.com Home | Fonts | Components | Labeling | Library | Order | Forum
  Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
General Discussion
 Community Forum : General Discussion
Subject Topic: question about barcode font 128A Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
gochtel
Newbie
Newbie


Joined: January 12 2006
Posts: 2
Posted: January 12 2006 at 5:41am | IP Logged Quote gochtel
hello,

first, sry for my bad english

I am searching for a barcode 128A font wich i can use in MS Word. I have to change for example 1234abcd into the barcode. After printing and scanning the result should be of course 1234abcd.

is it possible to change it directly in Word with font selection, or is this only possible with an extra program?

regards gochtel
Back to Top View gochtel's Profile Search for other posts by gochtel
 
glitch
Admin Group
Admin Group
Avatar

Joined: January 25 2003
Location: Canada
Posts: 280
Posted: January 12 2006 at 12:07pm | IP Logged Quote glitch

Code128 requires start/stop as well as checksum characters. Consequently you can not type the number and format the font to make the barcode; you need to generate the "barcode string" first and format the barcode string with the font to get the correct barcode.

You can use FontPal utility to transfer the barcode string to Microsoft Word.

Just a reminder - Code128A does not encode lower case letters. Code128B does.
Back to Top View glitch's Profile Search for other posts by glitch Visit glitch's Homepage
 
gochtel
Newbie
Newbie


Joined: January 12 2006
Posts: 2
Posted: January 13 2006 at 5:09am | IP Logged Quote gochtel
ok, thx for the answer.
Is the FontPal utility also in the demo package in your Barcode128FontPack? because i would like to test it, but i can´t find it in there
Back to Top View gochtel's Profile Search for other posts by gochtel
 
glitch
Admin Group
Admin Group
Avatar

Joined: January 25 2003
Location: Canada
Posts: 280
Posted: January 13 2006 at 8:18am | IP Logged Quote glitch

Yes it is in the demo package.

You need to run the setup.exe to get it installed. After intallation complete, you can find the shortcut on the desktop.
Back to Top View glitch's Profile Search for other posts by glitch Visit glitch's Homepage
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.3281 seconds.