How to enlarge printed 2D symbol when using ActiveX
3 posts • Page 1 of 1
How to enlarge printed 2D symbol when using ActiveX
by MKaprielian on Wed Sep 02, 2015 7:45 pm
I have successfully added QR codes into MS Access 2010 and can print the QR code.
On my report I would like the size of the QR code to be larger. Even though I have set the properties H and W to be 1 inch and the outline around the QR symbol on my report is that size, the actual QR printed seems to be limited to just under .5 inches.
How can I get the QR code itself to be larger? Is there information in the Manual that would answer this?
Mark
On my report I would like the size of the QR code to be larger. Even though I have set the properties H and W to be 1 inch and the outline around the QR symbol on my report is that size, the actual QR printed seems to be limited to just under .5 inches.
How can I get the QR code itself to be larger? Is there information in the Manual that would answer this?
Mark
- MKaprielian
- Posts: 2
- Joined: Wed Sep 02, 2015 7:36 pm
Re: How to enlarge printed 2D symbol when using ActiveX
by glitch on Thu Sep 03, 2015 9:10 am
To increase the physical size of QRCode, increase ModuelSize property. See http://www.morovia.com/manuals/qrcode-f ... ModuleSize
The information above is provided "AS IS", with no warranties, and confers no rights.
-
glitch - Support Engineer
- Posts: 198
- Joined: Wed May 14, 2008 2:42 pm
Re: How to enlarge printed 2D symbol when using ActiveX
by MKaprielian on Sat Sep 05, 2015 10:37 pm
Thank you
Mark
Mark
- MKaprielian
- Posts: 2
- Joined: Wed Sep 02, 2015 7:36 pm
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests