BarCode Inputs

[atifmushtaq(legacy member)]

Hello,

Sir,

I have check your barcode activeX this is good but I have Problem in it, that is when I Attech it to database and give "Message" below the Barcode then that is not match with the BarCode Reading, Plaese tell me that how can I set its Complete Value as I like,


Hope you will reply soon,

Thanks,

Atif Mushtaq
System Administrator,
CFR Foundation Pakistan,
37/H Club Road Vehari Pakistan,
Phone #: 0092-300-772-2586

[glitch (legacy member)]

We need more information, such as symbology type and message value. If you do not want to post here, send them to support@morovia.com with screenshots.

[atifmushtaq(legacy member)]

Thanks for reply

sir,

I use symbology type "Code-128" and message "1".

[glitch (legacy member)]

Most bar code scanners require a minimum code length - 4 characters or more. This is because the misread rate increases dramatically when there are less than 4 characters encoded in the barcode.
EitherIncrease the length of input or read the scanner manual to find out how to reduce the minimum code length requirement.